User's Manual
Table Of Contents
- Overview
- Standard Models
- Filter Kits
- Accessories
- Accessories for Stainless-Steel Weather-Resistant Enclosures
- Fiber Optic Options
- Installation
- RF Deck Connections
- Battery Backup
- In-Hancer Plus BDA Specifications
- Carrier De-Rating
- Indicators
- Configuration
- Antenna Installation
- FCC Information to Users
- Maintenance & Safety
- Standard Warranty
- Return & Repair
- Parts & Accessories
In-Hancer Plus BDA
USER MANUAL
DCM000000105
Connections
In-Hancer Plus BDA Connectors are on the bottom of the enclosure. RF cables can
be connected to these connectors using RF cables as follows.
Connect the in-building Distributed Antenna System cable to the Uplink port.
Connect the Donor Site cable to the Downlink port.
Connect AC Power.
Connect any Data Cables.
AC Power and RF Connections should be installed with all standard installation
practices for lightning protection. This includes the grounding and electrical bonding
together of all equipment racks and cabinets in the room. It also includes a
grounding of the primary antenna cable and the installation of proper surge
suppression (lightning arrestor) equipment at the entrance to the equipment room. It
is highly recommended that AC Power Wiring be performed by a qualified Electrician
so as to ensure compliance with all National and Local Electrical Wiring Regulations.
Connecting power cables can be done as follows:
The In-Hancer Plus BDA enclosure can be grounded by connecting a No. 6
copper grounding wire to the grounding stud located at the bottom of the
enclosure.
Connect the power cable to the AC INPUT connector located at the bottom of
the enclosure.
Set the In-Hancer Plus BDA operating parameters using a PC or via the CAN
Network.
Printed: 03.10.14,09:37
Revision Date:10/14/03
17