Operations Manual

Installation and Operation
MCPS2000 System Operation 9
Spectrian Proprietary -- See notice on first page
2.3 Prepare for Installation
Before beginning the installation, verify that all the necessary site and radio
information, installation materials, tools, and MPCS2000 equipment are on hand.
Correct any problems or omissions before continuing. If necessary, refer to the
following Receiving and Unpacking Procedure to prepare the MCPS2000
equipment.
Receiving and Unpacking Procedure
A Inventory Received Equipment
1. Upon receipt of the MC2004 remove the packing lists, installation kit, and other
documents attached to the shipping container.
2. Examine shipping documents to make certain that they agree with your copy of
the order. If there is a discrepancy between the order and the items or quantity
shipped, contact your Spectrian representative listed in the front of this manual.
3. Check the packing list and verify that all necessary equipment has been
delivered, and that the parts are undamaged. If any evidence of shipping damage
is noted, notify the delivery agency before continuing.
☛ NOTE: If the container or contents appear to be damaged, you must contact the
carrier without delay and file a damage claim. If shipping damage occurred, the
carrier may wish to have a claims agent present when theMCPS2000 is unpacked
and inspected. To protect your warranty rights, you must also notify your
Spectrian representative and advise that theMCPS2000 was damaged during
shipment.
B Unpack Received Equipment
Uncrating, inspecting, and preparing the MCPS2000 for site installation will require
some tools and materials not included in the shipment. Use of the following
materials is suggested to perform these tasks.
☛ Assemble all tools, materials, and safety equipment before beginning work.
Safety Equipment
• Safety glasses • Work gloves • Steel-toe shoes • Back-support belt
Tools
• Box knife • Pair of large scissors • Inspection flashlight or lamp
• Pen or pencil • Strap cutter • Straight-blade screwdriver
Other Materials
•Purchase Order (copy) • Packing List (copy)
1. Open the shipping container(s) and inspect the contents. Using the required
safety equipment and tools, carefully cut the metal and/or nylon straps that
surround the shipping containers. When using a box knife or scissors, take care
not to damage the contents of the box. Take care to avoid scratching the cabinet
finish.
2. Do not remove the ESD protective wrapping that surrounds the cabinet, unless
wearing and ESD protective wrist strap. If possible remove this material by
unwrapping the MCPS2000 by hand, rather than cutting this material with