Operations Manual

Installation and Operation
MCPS2000 System Operation 5
Spectrian Proprietary -- See notice on first page
2 Installation and Operation
2.1 Introduction
This chapter describes how to install, set up, and operate an MCPS2000 series
amplifier in a base station. The described installation verification checks should be
performed following installation of the MCPS2000 and after major maintenance or
repairs have been completed.
The main installation steps detailed in this procedure are as follows.
• Installation Planning
• Installation Preparation
• Rack Installation
• Cable and Wire Installation
• Verify Installation
• Power-Up the MCPS2000
• Determine Required RF Input Power
• Set RF Input Power for each Channel
2.1.1 Safety Information
Please read and understand the instructions and warnings in this section and at the
beginning of this manual before handling or unpacking the MCPS2000 modules.
The MCPS2000 is designed to be installed by trained and qualified technicians.
Each MCPS2000 amplifier module and the shelf subassembly weigh 20 kgs (44 lbs);
when crated for shipping an MCPS2000 system can weigh in excess of 100 kgs (220
lbs) and be unbalanced. To avoid injuries or damage, use care and obtain assistance
when lifting a crate containing MCPS2000 components.