User's Manual

Introduction
2 MCPS4080 Operations Manual



2001 Spectrian Corporation. All rights reserved.
Throughout this manual, notes, cautions and warnings are used with this
convention:
✎
Note: Sub-optimal or out-of-specification performance will result from not
following the instructions presented in ‘notes’.
☛
Caution: Follow ‘caution’ notes to avoid possible damage to equipment.
!
Warning: Injury to personnel, equipment fire, or other hazardous situations
will result from not properly following ‘warning’ instructions.
1.1.1 Equipment Changes
Spectrian Corporation reserves the right to make minor changes to the equipment,
including but not necessarily limited to component substitution and circuitry
changes. Modifications that impact this manual may subsequently be incorporated
in a later revision of this manual.
1.2 Safety Information
The MCPS4080 has been designed for maximum safety and reliability when it is
installed, used, and maintained in accordance with the procedures and instructions
in this manual by trained and qualified technicians. To ensure the safe and
compliant operation of the system, always follow the safety and operational
recommendations in this manual.
!
WARNING: The MCPS4080 produces high levels of RF radiation. Severe
radiation burns can occur if recommended safety precautions are not strictly
observed.
-- Do not operate exposed circuitry or radiating elements with personnel in close
proximity to the radiating source. Always replace covers and shields during
operation.
-- Persons with cardiac pacemakers should avoid exposure to RF radiating
elements.
-- Exposing the human eye to high levels of radio-frequency radiation may
result in the formation of cataracts.
!
WARNING: Do not install or operate theMCPS4080 amplifier in the presence
of flammable gases or fumes.
!
Each RF Module and the shelf subassembly weigh 22.7 kgs (50 lbs); when
crated for shipping an MCPS4080 system can weigh in excess of 131.5 kgs (290
lbs) and be unbalanced. To avoid injuries or damage, use care and obtain
assistance when lifting MCPS4080 components.
☛
Always use the recommended safety equipment.
☛
Please read and understand all instructions and warnings before handling an
MCPS4080.
☛
MCPS4080 amplifiers may only be installed in restricted access areas (dedicated
equipment rooms, equipment closets, or the like) in accordance with Article 110-
16. 110-17, and 110-18 of the National Electrical Code, ANSI/NFPA No. 70.