User's Manual

BDA1300 Equipment Manual
DCM000000018

Kaval Telecom Inc. Page 24 of 51
6 Antenna Installation
! All Antenna Installation is to be performed by Qualified Technical Personnel only.
! Antenna Installation Instructions and locations below, are for the purpose of satisfying FCC
RF Exposure Compliance requirements.
! The Roof Top Antenna for linking to the Donor Site is a directional (high gain) Antenna fixed-
mounted physically on the side or top of a building, or on a tower. The Antenna Gain must be
no more than 10 dB. The Roof Top Antenna location should be such that only Qualified
Technical Personnel can access it, and that under normal operating conditions no other
person can touch the Antenna, or approach within 10 meters of the Antenna.
! The In-Building Antenna connection is via a coaxial cable distribution system with Signal
Taps at various points connected to the fixed-mounted Indoor Antennae. This is shown in the
figure in the Introduction. The Indoor Antennae are simple 1/4 Wavelength (0 dB Gain) types.
They are used with Kaval 12, 16, or 20 dB Cable Taps. As such the maximum EIRP will be at
the first Tapped Antenna, which will be 12 dB below the maximum signal level of the BDA1300
+25 dBm, or 0.32 Watts EIRP. These Antennae are to be installed such that no person can
touch the Antenna, or approach within 0.2 Meters.
ANTENNA INSTALLATION
WARNING
ALL ANTENNA INSTALLATION IS TO BE PERFORMED BY QUALIFIED TECHNICAL
PERSONNEL ONLY.
ANTENNA INSTALLATION INSTRUCTIONS AND LOCATIONS ARE FOR THE PURPOSE
OF SATISFYING FCC RF EXPOSURE COMPLIANCE REQUIREMENTS, AND ARE NOT
OPTIONAL.
ALL ROOF TOP ANTENNA INSTALLATION MUST BE SUCH THAT NO PERSON CAN
TOUCH THE ANTENNA, OR APPROACH CLOSER THAN 10 METERS.
ALL IN-BUILDING ANTENNAE INSTALLATIONS MUST BE SUCH THAT NO PERSON
CAN TOUCH THE ANTENNAE, OR APPROACH CLOSER THAN 0.2 METERS.