User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
9
. OMT32 Features
This chapter describes features related to the OMT32 program and its
operation, i.e. OMT32 preferences and features that can be performed
without connecting to a repeater. Operations that require connection to a
repeater are found in Chapter 10, Repeater Operations.
The following features are described:
• Connection parameters, page 9-2.
Parameters for local and remote connection to repeaters.
• CLI, Command Line Interface, page 9-6.
Syntax and commands used for the Command Line Interface.
• Cellular calculator, page 9-8.
Shows channel data for various systems and channels.
• OMT32 version, page 9-9.
Software part number and version for the OMT32.
• Exiting OMT32, page 9-10.
The various ways to exit the OMT32.
ALLGON System AB AR Repeaters & OMT32 Software – OMT32 Features
User’s Manual VD202 90/EN Rev. 1A 1999-07 9 - 1