User's Manual

After connection to the repeater the status bar text shows the repeater
type and, if a combined repeater, active part. Available repeater types:
- Channel selective
- Band selective
- Combined
- CDMA
Message Log
The message log contains all commands and OMT32 actions in
chronological order since the OMT32 was last started.
The message log can be printed out by selecting the Print Message Log
option in the File menu.
Main menu and button bar
From the OMT32 main window you have access to all features, which can
be selected in the following ways:
1. By clicking the buttons in the button bar. The most frequently used
commands have buttons.
2. By selecting from the main menu. A reference guide, containing all
the main menus, is found in Appendix A - Menu Reference Guide.
3. By selecting from the main menu using the <Alt> key and the
underlined menu letter simultaneously, e.g. <Alt> + A and o gives
the Logoff command in the Access menu.
4. By using the short key commands indicated in the main menus,
e.g. <F2> gives the Connect command in the Access menu.
5. By typing the commands using the Command Line Interface (see
below).
Command Line Interface
Some commands can be entered using the Command Line Interface, CLI.
The CLI is accessible by clicking the icon shown in the main window, or
by selecting the Command Line Interface option in the Advanced
menu.
Further information about this feature is found in the Command Line
Interface section in Chapter 9.
ALLGON System AB AR Repeaters & OMT32 Software – Getting Started
User’s Manual VD202 90/EN Rev. 1A 1999-07 8 - 11