User's Manual

Remote Connection
If you have selected remote control, the Dial Repeater dialog box is shown,
in which you can select a repeater to connect to:
Repeater ID
This option enables the repeater list containing repeater names and phone
numbers.
The included repeaters are sorted in alphabetic order.
Phone list file
Shows the file in which the repeater list with the phone numbers is stored.
Repeater Phone Number
Repeater phone numbers (area codes and phone numbers) to the repeaters
which are to be called.
Phone number
By clicking this option, you can enter and use a second phone number to
the highlighted repeater, without changing the permanent number. To
reset to the first number, click the Repeater ID option.
Ignore dialing properties
The dialing parameters set in the Remote Connection Parameters dialog
box (see the Remote Connection section in Chapter 9) are ignored at
dialing, if this box is checked.
Figure 8-3. Dialing repeater for remote connection
ALLGON System AB AR Repeaters & OMT32 Software – Getting Started
User’s Manual VD202 90/EN Rev. 1A 1999-07 8 - 4