User's Manual

Connecting Repeater
The target repeater must be in operation when connecting to it.
If the repeater is not in operation when connecting to it, then the OMT32
cannot receive requested information from the repeater, such as the
repeater type.
A steady yellow light on the repeater front indicator shows that the
repeater is in operation.
Click the local or remote connect button or select the Connect option in
the Access menu to connect OMT32 locally or remotely to a repeater.
The following dialog box is shown if you use the menu option:
Local
Select this option if the PC is locally connected to the repeater with a
cable.
On this option, the OMT32 will show a logon box (described on page 8-6).
Remote via modem
Select this option if the PC is remotely connected to the repeater via
modem and a telephone line or a mobile phone.
On this option, the OMT32 will show a dialing box for selecting phone
number to the repeater (described on page 8-4).
Ok
After selecting local or remote connection, click the Ok button.
Figure 8-2. Local or remote connection
ALLGON
ALLGON System AB AR Repeaters & OMT32 Software – Getting Started
User’s Manual VD202 90/EN Rev. 1A 1999-07 8 - 3