User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Status Bar Help
The status bar at the bottom of the main window, see Figure 7-1, shows
some button and main menu information.
Manuals
The following comprehensive manuals are available for the repeaters and
the OMT32 software.
• The AR Repeaters & OMT32, User’s Manual is available as hardcopy as
well as in PDF-format.
Hardcopy manual part # is VD 202 90/EN (English version).
The same manual in PDF format is found in the Doc folder on the
OMT32 CD-ROM as OMT32-EN.PDF (English version).
• The R2R, Repeater to Repeater Link Kit, Installation Guide is available
as hardcopy as well as in PDF-format.
Hardcopy manual part # is VD 202 91/EN (available in English only).
The same manual in PDF format is found in the Doc folder on the
OMT32 CD-ROM as R2R-EN.PDF.
An Acrobat Reader installation file is included in the OMT32 CD-ROM as
well. It is found in the Acrobat filder.
Figure 7-1. Status bar help
ALLGON System AB AR Repeaters & OMT32 Software – Help
User’s Manual VD202 90/EN Rev. 1A 1999-07 7 - 2