User's Manual

Initial OMT32 Settings
The OMT32 initial settings can be changed by using the OMT32 Setup as
follows:
1. Male sure that the OMT32 is not running.
2. Click the OMT Setup icon.
The Find OMT Installations dialog box is shown, which is used to
find OMT program files on the computer disks. This can e.g. be used
when removing an old OMT version from the system.
To find Allgon OMT program files in the computer system, click the
Scan button. Check the Include Network Drivers box to search
also on connected network drives.
If you want to interrupt a search process, click the Break button.
The result is displayed as shown in Figure 6-10.
When ready, or if you do not want to use the search feature, click the
Next> button.
3. The OMT Basic Parameters dialog box is shown (see page 6-4). The
company and user name, and the window settings can be changed.
4. The OMT Communication Parameters dialog box is then shown (see
page 6-5). Modem and local ports, modem speed and initiation string,
and the OMT32 phone number can be changed.
5. Finally, the OMT Log File Settings dialog box is shown (page 6-6).
The log file can be selected in this box.
The setup program is then finished.
Figure 6-10. Locating OMT program files
ALLGON System AB AR Repeaters & OMT32 Software – OMT32 Installation
User’s Manual VD202 90/EN Rev. 1A 1999-07 6 - 12