User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Automatic OMT32 Recovery
For information about how to configure the system to recover
automatically after a system breakdown, e.g. after a power failure, refer to
the Windows manual.
Screen Saver
Some screen savers might have a disturbing effect on OMT32. To ensure
a proper OMT32 functionality, check the specific screen saver you intend
to use by running it while OMT32 is in operation.
Uninstalling OMT32
If you want to uninstall OMT32, use the Windows system feature that
removes the program files and program related files and information from
the system. This feature is available by selecting the Settings,
Control Panel, and Add/Remove Programs in the Start menu.
The following software component is installed for OMT32 and is to be
removed:
OMT32
For further information about uninstalling programs, refer to the
Windows manual and on-line help.
ALLGON System AB AR Repeaters & OMT32 Software – OMT32 Installation
User’s Manual VD202 90/EN Rev. 1A 1999-07 6 - 10