User's Manual

Software Installation
1. Start Windows. If you install OMT32 under Windows NT 4.0, you
must log on with privileges to change the system registry, normally
as Administrator.
2. Make sure that no applications except Windows is running.
3. Insert the OMT32 disc in the CD-ROM drive (or disk 1 in the disk
drive if you prefer to install by using copied disks).
4. If the install program does not start automatically, select Run in the
Start menu and type on the command line:
X:\setup (substitute the drive letter used for X).
Or, you can click or the Browse button and select the setup.exe file.
When ready, click the OK button.
5. In the Welcome dialog box, click the Next> button to proceed.
6. In the User Information dialog box, type your name and your
company name and click the Next> button.
7. In the Choose Destination Location dialog box, set the path for the
program folder. If you click the Browse button, you can choose an
existing folder.
When ready, click the Next> button.
8. In the Setup Type dialog box, select Typical, Compact or Custom
installation. Typical installation is recommended. Custom lets you
choose components to be installed. You can also change the path for
the program folder in this dialog box.
When ready, click the Next> button.
Figure 6-1. Setup type
ALLGON System AB AR Repeaters & OMT32 Software – OMT32 Installation
User’s Manual VD202 90/EN Rev. 1A 1999-07 6 - 2