User's Manual

Connection Ports and Station Ground
The DIA distribution board provides most of the internal connection
between the repeater units, and to external ports. Connectors involved in
the installation are also located on the DIA board. These connectors are
described below. A complete DIA board connector list is found in the
Board and Unit Descriptions section in Chapter 5.
Station ground is detailed below as well.
Station Ground
There is a station ground screw (M8) in the repeater marked with a
ground symbol (see Figure 3-7). This screw must be used only for station
grounding (if such ground is to be used).
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
OUT
LOW
IN ATT +7V OUT1 OUT2
LNA
UL
OUT
LOWIN+7V ATTOUT1 OUT2
LNA
DL
MS BS
DPX DPX
MS
BS
CMB CMB
DL UL
P33
P27
P31
DC
MS
-20 dB
P32
P28
P34
Figure 3-7. Connection ports and station ground
ALLGON System AB AR Repeaters & OMT32 Hardware – Installation
User’s Manual VD202 90/EN Rev. 1A 1999-07 3 - 9