User's Manual

Dimensions and Weights
The dimensions of the repeater, including the mounting bracket, is shown
in Figure 3-1. The repeater chassis consists of two main parts, a cabinet
in which the circuitry is housed, and a cover, which can be either a thin
cover or a large cover (see the figure) depending on the configuration.
Approximately repeater weights
Channel selective repeater, four channels, thin cover ............ 21 kg (46 lbs)
Channel selective repeater, four channels, large cover ........... 25 kg (55 lbs)
Band selective repeater, thin cover .......................................... 21 kg (46 lbs)
Band selective repeater, large cover ......................................... 25 kg (55 lbs)
Channel/band selective combi repeater, large cover ............... 30 kg (66 lbs)
If the cover, for some reason, has to be lifted off the cabinet, disconnect
the interconnection cables, remove the hinge nuts, and lift the cover off.
This is not recommended in other than exceptional cases.
The cabinet and cover weights are, approximately, as follows:
Empty thin cover .......................................................................... 6 kg (13 lbs)
Empty large cover ...................................................................... 10 kg (22 lbs)
Equipped large cover .................................................................. 15 kg (33 lbs)
Equipped cabinet without cover ............................................... 15 kg (33 lbs)
440 (17.3")
530 (20.9")
520 (20.5"
)
110 (4.3")
ALLGON
174 (6.9")
224 (8.8")
240 (9.4")
290 (11.4")
Mounting
bracket
Cabinet Shelter
Thin
cover
Large
cover
Figure 3-1. Repeater dimensions
ALLGON System AB AR Repeaters & OMT32 Hardware – Installation
User’s Manual VD202 90/EN Rev. 1A 1999-07 3 - 2