User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Alarm Modems
Opens an R2R alarm configuration dialog box.
See the Alarm Configuration section in Chapter 13.
Node Configuration
Opens an R2R node configuration dialog box.
See the Node Configuration section in Chapter 13.
Link Speed
Opens an R2R communication dialog box intended for fault tracing.
See the R2R, Communication Problem section in Chapter 12.
Advanced node Configuration
Opens an R2R communication dialog box intended for fault tracing.
See the R2R, Advanced Node Configuration section in Chapter 12.
Repeater Messaging
This feature is not implemented in the current version.
Command Line Interface
Opens the command line for entering CLI commands.
See the Command Line Interface section in Chapter 9.
ALLGON System AB AR Repeaters & OMT32 Appendix A - Menu Reference Guide
User’s Manual VD202 90/EN Rev. 1A 1999-07 A - 10