User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Advanced
OMT Modem Debug
This option is intended for service and trouble shooting.
Opens an OMT32 modem debug tool. This tool contains a list of
AT commands which can be sent to the modem.
This option is only available when OMT32 is not connected to a repeater.
Repeater Modem Debug
This option is intended for service and trouble shooting.
The same feature as the previous OMT Modem Debug option, but for the
repeater modem.
This option is only available when OMT32 is locally connected to the
repeater.
Communication Link Status
This option is intended for service and trouble shooting.
Shows continuously updated information about the communication
between OMT32 and the repeater.
Repeater Network
Opens the following sub menu:
Network
Opens an R2R network settings window.
See the Network Settings section in Chapter 13.
Statistics
Opens an R2R network statistics window.
See the Network Statistics section in Chapter 13.
ALLGON System AB AR Repeaters & OMT32 Appendix A - Menu Reference Guide
User’s Manual VD202 90/EN Rev. 1A 1999-07 A - 9