User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
CU Board
Shows the values from the testpoints located on the CU board.
See the CU Board section in Chapter 10.
Modem
Shows information from the repeater modem.
See the Repeater Modem section in Chapter 10.
Received Repeater Alarms
Shows the alarm list received from one or several repeaters.
See the Received Repeater Alarms section in Chapter 11.
Repeater Event Log
Shows the repeater event log contents.
See the Repeater Event Log section in Chapter 11.
Alarm Reset
Clears all alarms and resets all process counters in the repeater.
The reset procedure does not affect uplink or downlink communication in
progress.
See the Alarm Reset section in Chapter 11.
ALLGON System AB AR Repeaters & OMT32 Appendix A - Menu Reference Guide
User’s Manual VD202 90/EN Rev. 1A 1999-07 A - 8