User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Main Menu Reference Guide
The main window has the following menu:
This menu is described below.
File
Print Message Log
Prints the contents of the Message Log, further detailed in the description
of the OMT32 main window.
See the Main Window After Logging On section in Chapter 8.
Printer Setup
Opens the Windows standard printer setup dialog box.
Exit
Logs you off from the repeater (if logged on) and exits the OMT32.
See the Exiting OMT32 section in Chapter 9.
ALLGON System AB AR Repeaters & OMT32 Appendix A - Menu Reference Guide
User’s Manual VD202 90/EN Rev. 1A 1999-07 A - 2