User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
RIA Board Version
The version of the link communication RIA board (Repeater to Repeater
Interface Adapter) can be detected remotely by OMT32.
See the Repeater Boards (CHA/BSA/CSA/PA/RIA) section in Chapter 10.
Troubleshooting
The following procedures are fault tracing tools and are thus found in
Chapter 12, Troubleshooting:
• Link speed setting
• Advanced node configuration
ALLGON System AB AR Repeaters & OMT32 Optional
User’s Manual VD202 90/EN Rev. 1A 1999-07 13 - 15