User's Manual

R2R, Repeater To Repeater Link
The Allgon Repeater to Repeater Link can be used in order to establish a
repeater network with up to 13 repeaters, one or several of which can
contain a phone line for communication with an OMT32 or an OMS.
Channel selective repeaters as well as band selective repeaters can be
included and mixed in the network.
Repeaters can either be equipped with this feature at the delivery from
Allgon, or be completed with a Repeater to Repeater Link Kit, provided the
repeaters meet the following requirements.
Requirements
To be able to use the Repeater to Repeater Link feature, the following DIA
board, CU board and CU software is required:
DIA board K105/1 version R2A or higher
CU board K103/2 version R1A or higher
CU software SA102 02/1 version R3A or higher
Further information and requirements are found in the R2R installation
document, R2R, Repeater to Repeater Link Kit, Installation Guide
(part # VD202 91/EN).
R2R Installation
The R2R, Repeater to Repeater Link is installed as described in the
R2R, Repeater to Repeater Link Kit, Installation Guide.
Figure 13-4. Repeater to Repeater Link
ALLGON System AB AR Repeaters & OMT32 Optional
User’s Manual VD202 90/EN Rev. 1A 1999-07 13 - 9