User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
R2R, Advanced Node Configuration
There is a fault tracing tool for advanced node configuration of the R2R
net. This tool is included in the OMT32.
To be able to use this tool, connect the repeater locally to the OMT32/PC
and start up OMT32 and the repeater.
When the repeater and OMT32 is running, open the link speed dialog box
by selecting the Repeater Network option in the Advanced menu, and
then the Advanced Node Configuration option.
The entries in this dialog box are not explained here because if you are
not already familiar with the functions, you cannot use this tool.
The Update button enters the modifications made into the repeater.
The Restore Defaults button sets all parameters to the default settings.
Figure 12-5. Advanced node configuration
ALLGON System AB AR Repeaters & OMT32 Troubleshooting
User’s Manual VD202 90/EN Rev. 1A 1999-07 12 - 6