User's Manual
Table Of Contents
- Front Page
- Contents
- Figures
- New Features in OMT32 Version R1A
- Abbreviations
- Part 1 – Hardware
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- Part 2 – Software
- 6. OMT32 Installation
- 7. Help
- 8. Getting Started
- 9. OMT32 Features
- 10. Repeater Operations
- 11. Alarms and Events
- 12. Troubleshooting
- 13. Optional
- Appendix A - Menu Reference Guide
- Index
- Questionnaire
Disabling/Enabling Remote Alarm Reception
Alarm information can be sent from a repeater to a remote connected
OMT32/PC, in which the alarm information is stored and can be displayed
in the Received Repeater Alarms window (page 11-6).
The reception of the alarm information can be disabled/enabled.
Disabling Remote Alarm Reception
To disable the reception, select the Disable Remote Alarms option in
the OMT Preferences menu.
The Disable Remote Alarms option in the OMT Preferences menu
will be shaded after this action, which indicates that the alarm reception
is disabled.
Enabling Remote Alarm Reception
To enable the reception, select the Enable Remote Alarms option in the
OMT Preferences menu.
The Enable Remote Alarms option in the OMT Preferences menu
will be shaded after this action, which indicates that the alarm reception
is enabled.
ALLGON System AB AR Repeaters & OMT32 Software – Alarms and Events
User’s Manual VD202 90/EN Rev. 1A 1999-07 11 - 8