User's Manual

Downloading CU Software
The purpose of this procedure is to get opportunity to download new
software to the Application 1 or Application 2 area on the CU board.
After a following reboot, the downloaded application can be the
Current application.
The download process can be performed either locally or remotely.
If incorrect software is downloaded, or the download process is interrupted,
the repeater may be blocked and, in worst case, damaged. If this happens
when the process is remotely controlled, a visit to the repeater site will be
necessary. If the repeater is damaged, it might be necessary to replace the
CU board.
Avoid downloading CU software to the primary area because an
interrupted process will result in an incomplete CU software, on which the
repeater will not be able to reboot.
Download the CU software as follows:
1. If the software to be downloaded is stored on a floppy disk, insert the
disk in the disk drive.
2. Click the Update 1 or Update 2 button to download the software as
Application 1 or Application 2 respectively.
3. Select software file to be downloaded:
If you have the README.TXT release information file on the same
disk, this file is shown provided the Show README file, if available
box is checked in the CU Revision Manager window (page 10-40).
Take this opportunity to read the release information carefully. If you
do, you will probably get a lot of valuable information and perhaps
save time an trouble.
Application 1 Application 2
Current application
Boot version
Figure 10-26. Select software file for downloading
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 43