User's Manual

Current application
Shows that application which the repeater is booted on.
Current application can be loaded from Application 1 or Application 2.
Application 1
Application 1 is a CU software stored on the CU board. The repeater can
be booted on this application, which then becomes the current application.
Application 2
Application 2 is a second CU software stored on the CU board which the
repeater can be booted on.
Application 1 and Application 2 status
Application 1 and Application 2 can have the following status:
PRIMARY The repeater is booted on the primary application at
startup and on a reboot command with the Reboot
button.
SECONDARY The repeater is not booted on a secondary application
but it can be selected to primary by clicking the
Primary switch.
BLOCKED A blocked application shall not be used. It is marked
as blocked in the Block box.
SOFTBLOCKED If an application crashes more than ten times then it is
marked SOFTBLOCKED and cannot be used any more.
NOT EXISTING This status means that there is no software stored in
this application area.
ERROR An error or interruption has occurred during an
application downloading from OMT32 to the repeater
CU board.
Show README file, if available
If you have the README.TXT release information file on the same disk
as the new CU software when downloading it, this file is shown provided
this box is checked (see page 10-43).
Application 1 Application 2
Current application
Boot version
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 41