User's Manual

Band Selective Repeater
The status window shows continuously updated operational status for the
selected repeater.
The upper part of the window shows alarm, which is common information
for the whole repeater.
The lower part of the window shows uplink and downlink operational
status.
Field description:
Alarm Level
Shows the text NONE when there is no active alarm. The alarm level is
shown if an alarm is active. Alarm and alarm levels are further detailed
in the Alarm Overview section in Chapter 11.
Specific status Gain set to
Uplink and downlink gain set in the configuration window (page 10-11).
Control to
This field shows the calculated uplink and downlink setpoint values based
on the values in the Gain set to fields. Normally, they coincide with the
Gain set to values.
Figure 10-12. Band selective repeater status
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 23