User's Manual

Button bar Select CDMA Channel
Select a CDMA channel by clicking the corresponding button in the
button bar. Those channel numbers which were selected in the
configuration window (page 10-8) are shown on the buttons.
Only CSA boards present in the repeater are indicated with button
numbers. CSA boards not present are shown as non-numbered buttons.
Specific Status CDMA channel
This field shows the selected channel number for which the specific
information is displayed.
Mode
The current operational mode, which can be:
START UP System startup. Normal startup time is 10 - 20 seconds
after the mains is switched on.
OPERATE Selected channel is in operation.
BLOCK Selected channel is not in operation. An error may have
occurred.
OFF Selected channel is set to inactive in the configuration
window (page 10-8).
Gain set to
Uplink and downlink gain set in the configuration window (page 10-8).
Used gain
Actual momentary gain for uplink and downlink transmission based on
the Gain set to value.
Normally, the Used gain coincides with the Gain set to value.
The Used gain can be decreased not to exceed the Max output power set
(page 10-8). See Gain reduction alarm on page 10-10.
RSSI
Input signal level from the antennas.
AGC
Shows the text ON or OFF to indicate if the AGC (automatic gain
control) for uplink and downlink signaling is on or off.
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 21