User's Manual

Channel Selective CDMA Repeater
The status window shows continuously updated operational status for the
selected repeater.
To select channel, click a button in the Select CDMA Channel button bar.
Below the channel button bar, the information is specific to the selected
channel.
Field description:
Input attenuation
Uplink (MS) and downlink (BS) input signal attenuation (not applicable
to all versions).
Common Status
The AGC status field can show AGC information such as Gain reduced
(see Gain reduction alarm on page 10-10), and general information such
as Error! at signal amplification failure.
At normal operation, this field is blank.
Output power
Shows the output power to the uplink and downlink antennas. Maximum
power is set in the configuration window (page 10-8).
Figure 10-11. Channel selective CDMA repeater status
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 20