User's Manual

Button bar Select GSM Channel
You can select GSM channel to be shown by clicking the corresponding
button in this button bar. Those channel numbers which were selected in
the configuration window (page 10-6) are shown on the buttons.
Only CHA boards present in the repeater are shown with button
numbers. CHA boards not present are shown as non-numbered buttons.
Specific Status Active GSM channel
Selected channel number for which the specific information is shown.
Mode
The current operational mode, which can be:
START UP System startup. Normal startup time is 10 - 20 seconds
after the mains is switched on.
OPERATE Selected channel is in operation.
BLOCK Selected channel is not in operation. An error may have
occurred.
OFF Selected channel is set to inactive in the configuration
window (page 10-6).
Gain set to
Uplink and downlink gain set in the configuration window (page 10-6).
Control to
Calculated uplink and downlink setpoint values based on the values in the
Gain set to field. Normally, they coincide with the Gain set to values.
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 15