User's Manual

Repeater Configuration
The purpose of channel selective repeater configuration is to set channel
numbers, gain and combiner attenuation. For band selective repeaters,
gain and frequency band edges are set.
The configuration window is opened by clicking the configuration button
or by selecting the Configuration option in the Operations menu.
If you are connected to a combined channel/band selective repeater, then
you can swap between channel selective active part and band selective
active part (described on page 10-3).
You can make changes in most of the configuration window fields.
Modifications made in the configuration windows are downloaded to the
repeater by clicking the Update button.
Values out of range are not accepted. An input error message is shown to
inform about invalid values:
Figure 10-2. Invalid input value
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 4