User's Manual

Active Repeater Part (Combined Repeaters Only)
If the connected repeater is a combined channel/band selective repeater,
you can swap between the channel selective and the band selective part.
Current active part status can be read either on the button bar at the
upper part of the main window, or on the status bar at the left bottom of
the main window:
There are three ways of swapping active repeater part:
1. Select the Repeater Type option in the Repeater Preferences
menu and click the Change button. This option gives also
information about current active part:
2. Select Active Repeater Part in the Operations menu.
3. Click the BSel/CSel button.
Channel and band selective specific windows are changed when swapping
between active repeater part.
Figure 10-1. Active repeater part
ALLGON System AB AR Repeaters & OMT32 Software – Repeater Operations
User’s Manual VD202 90/EN Rev. 1A 1999-07 10 - 3