User's Manual

Speed
Modem transfer speed in bps (baud rate) for the OMT32/PC modem.
Dialing Properties
Dialing properties for dialing from repeaters to OMT32 and the other way
round, i.e. from OMT32 to repeaters.
Parameters for calling repeaters can be ignored at dialing by checking the
Ignore dialing properties box in the Dial Repeater dialog box (described in
the Remote Connection section in Chapter 8).
Area code
Area code to the place where the OMT32 is located. Enter any prefix, if
applicable.
This area code will be used by repeaters when dialing OMT32, if dialing
from other areas.
Country code
The country code to the place where the OMT32 is located. Enter the
country prefix, if applicable.
This country code will be used by repeaters when dialing OMT32, if
dialing from abroad.
Outside line prefix, local
The prefix to get the line where the OMT32 is located. A common prefix
for companies is ’0’ to come through the switchboard.
This prefix will be used by OMT32 when dialing repeaters.
Long distance
Prefix to be used for long distance call, e.g. any long distance block code,
etc. Enter also the prefix to get the line where the OMT32 is located (the
same as the previous code) if this also is to be used. This field will thus
include the complete code required to make a long distance call.
This code will be used by OMT32 when dialing repeaters in other areas.
Dialing method
Select either Tone dial or Pulse dial for dialing OMT32. Pulse dial may
be used in old systems.
The dialing method will be used by repeaters when dialing OMT32.
ALLGON System AB AR Repeaters & OMT32 Software – OMT32 Features
User’s Manual VD202 90/EN Rev. 1A 1999-07 9 - 5