User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
Installation
The R2R, Repeater to Repeater Link is installed as described in the
R2R, Repeater to Repeater Link Kit, Installation Guide.
At least one RCU unit (or telephone line with modem) is required for
remote communication.
Configuration
Configuration is described in the OMT32, User’s Manual.
Optionals AR Repeaters Allgon Systems AB
6 - 10 Rev. P1A 2000-09 User’s Manual VD203 66/EN