User Manual

R2R, Repeater To Repeater Link
The Allgon Repeater to Repeater Link can be used in order to establish a
repeater network with up to 13 repeaters, one or several of which can
contain a phone line for communication with an OMT32 or an OMS.
All Allgon repeaters can be included in a R2R net (see Figure 6-4).
Channel selective repeaters, band selective repeaters, and Compact
repeaters can be mixed in the same net. For Compact repeaters, the R2R
Repeater to Repeater Link feature is standard and requires no extra
hardware or software.
AR Repeaters can either be equipped with this feature at the delivery
from Allgon, or be completed with a Repeater to Repeater Link Kit,
provided the repeaters meet the below requirements.
Requirements
To be able to use the Repeater to Repeater Link feature, the following DIA
board, CU board and CU software is required:
DIA board K105/1 version R2A or higher
CU board K103/2 version R1A or higher
CU software SA102 02/1 version R3A or higher
The version of the RIA board can be detected remotely by means of the
OMT32, see the OMT32, User’s Manual.
Further information and requirements are found in the R2R installation
document, R2R, Repeater to Repeater Link Kit, Installation Guide
(part # VD202 91/EN).
Figure 6-4. Repeater to Repeater Link
Allgon Systems AB AR Repeaters Optionals
User’s Manual VD203 66/EN Rev. P1A 2000-09 6 - 9