User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
RCU for Wireless Connection
The RCU base unit for Wireless Connection is mounted inside the
repeater cabinet, in front of the PSU (see Figure 6-3).
The bracket for the mobile phone is mounted in the upper right corner of
the cabinet. The mobile phone is placed in the phone holder.
The RCU is connected to the P27 and P32 ports as described in the
Connection section in Chapter 3.
The mobile phone antenna is connected to the MS -20dB port on the BS
directional coupler (DC) located to the right in the cabinet.
The mobile battery charger is connected to the mobile phone.
12volt 0.7Ah
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
OUT
LOW
IN ATT +7V OUT1 OUT2
LNA
UL
OUT
LOW
IN+7V ATTOUT1 OUT2
LNA
DL
Figure 6-3. RCU - Wireless PCMCIA type
Optionals AR Repeaters Allgon Systems AB
6 - 6 Rev. P1A 2000-09 User’s Manual VD203 66/EN