User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
RCU for Fixed Wire Line Connection
The RCU for Fixed Wire Line Connection is mounted inside the repeater
cabinet, in front of the PSU (see Figure 6-2).
The RCU is connected to the P27 and P32 ports as described in the
Connection section in Chapter 3.
A free strain relief bushing at the bottom of the repeater is used for the
external telephone line cable.
RCU kit items - Fixed Wire Line Connection
The item numbers refer to the numbers in Figure 6-2.
1. PCMCIA modem card host.
2. PCMCIA modem card (not included in the kit).
3. Green LED on the battery charger which is lit with a steady light
when the power supply is OK, either from the mains or from the
battery.
4. Yellow LED on the battery charger which is lit with a steady light
during battery charge from the mains.
Do not forget to put a jumper between pin 2 and 3 on the P27 connector if
you disconnect the RCU.
12volt 0.7Ah
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
Figure 6-2. RCU - Fixed Wire Line PCMCIA type
Allgon Systems AB AR Repeaters Optionals
User’s Manual VD203 66/EN Rev. P1A 2000-09 6 - 5