User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
Repeater CU Software and Hardware Compatibility
There are different versions of repeater CU software, which can be
combined with boards of various revisions. These have unique part
numbers and revision information. Below, you will find a table of
repeater software currently available in combination with CU board
revisions.
CU Software
Part #
Latest
Software
Revision
Compatible
with
CU board
Comments
SA102 01/2 R2E K103/1
or
K103/2
For GSM channel selective
≤ 4 channels, band selective
800-900MHz fixed band
width only, and combi
(800/900MHz).
No traffic statistics.
SA102 02/1 R3A K103/2 For GSM, EGSM, DCS,
PCS channel selective
≤ 8 channels, band selective
800-900MHz fixed or
adjustable band width,
band selective 1800MHz or
1900MHz and combi.
Supports R2R link.
SA102 02/2 R2A K103/2 For 800/1900MHz CDMA
≤ 4 channels.
This information is updated 2000-10-01. As new versions of hardware
and software are released without prior noticing, contact your Allgon sales
representative if in doubt about the latest revision status.
For detailed information, refer to the release notes for the CU software to
be downloaded (normally found in the readme.txt file, which is supplied
with the program files).
Functional Description AR Repeaters ALLGON System AB
5 - 26 Rev. P1A 2000-09 User’s Manual VD203 66/EN