User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
When the indicators show operational mode, the repeater can be
configured for operation by using a computer running OMT32. This is
further detailed in the OMT32, User’s Manual.
Indicators
Figure 4-1 shows the repeater indicators and the mains switch. There are
also two external indicators on the repeater front cover.
Repeater to Repeater Link
indicators
Additional indicators are found in the repeater, if equipped with the
Repeater to Repeater Link feature. For information about these indicators,
refer to the VD202 91/EN R2R, Repeater to Repeater Link Kit, Installation
Guide.
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
MS
DPX
ANT
TEST
DC
-30 dB
-20 dB
OUT
LOW
IN ATT +7V OUT1 OUT2
LNA
UL
OUT
LOWIN+7V ATTOUT1 OUT2
LNA
DL
OPER
ALARM
PWR
PWR
BOOT
ALARM
OPER
CU
ALI
S
DC
TEST
-30 dB
MS
DC
TEST
-30 dB
BS
V
Figure 4-1. Indicators and mains switch
Allgon Systems AB AR Repeaters Commissioning
User’s Manual VD203 66/EN Rev. P1A 2000-09 4 - 3