User Manual
Table Of Contents
- Front Page
- Pretext
- Contents
- Figures
- Abbreviations
- 1. Safety
- 2. Introduction
- 3. Installation
- 4. Commissioning
- 5. Functional Description
- Repeater Design
- Block Diagram
- Board and Unit Descriptions
- DC - Directional Coupler
- DPX - Duplex Filter
- LNA - Low Noise Amplifier
- CHA - Channel Amplifier Board for Channel Selective Operation
- CSA and PA Boards for Channel Selective CDMA Operation
- BSA and PA Boards for Band Selective Operation
- DIA Board
- CU Control Unit Board
- Repeater CU Software and Hardware Compatibility
- Cabling
- 6. Optionals
- 7. Repeater Alarms
- Index
- Questionnaire
Approximately repeater weights
Channel selective repeater, four channels, thin cover ............ 21 kg (46 lbs)
Channel selective repeater, four channels, large cover ........... 25 kg (55 lbs)
Band selective repeater, thin cover .......................................... 21 kg (46 lbs)
Band selective repeater, large cover ......................................... 25 kg (55 lbs)
Channel/band selective combi repeater, large cover ............... 30 kg (66 lbs)
Channel selective high power CDMA repeater, large cover ... 30 kg (66 lbs)
It is not recommended to remove the cover from the cabinet at the site.
However, if the cover, for some reason, has to be removed from the
cabinet, then disconnect the interconnection cables, close the cover,
remove the hinge shafts, and remove the cover.
The cabinet and cover weights are, approximately, as follows:
Empty thin cover .......................................................................... 6 kg (13 lbs)
Empty large cover ...................................................................... 10 kg (22 lbs)
Equipped cabinet or large cover ............................................... 15 kg (33 lbs)
Allgon Systems AB AR Repeaters Installation
User’s Manual VD203 66/EN Rev. P1A 2000-09 3 - 3