User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGH[
WLDM001B
TIU, see Traffic Interface Unit
TNC connector................17
, 19, 33
tools
for indoor installation .............16
for outdoor installation...........34
torque wrench ...................... 34
, 80
traffic channels
configuration..........................63
connecting to backplane........63
connecting to MUX................63
connectors....................... 29
–30
Traffic Interface Unit............. 17
, 20
balanced................................22
balanced, cables for ..............28
balanced, connecting ............28
Ethernet.................................23
Ethernet, connecting .............30
mounting................................20
port ........................................59
product numbers .....................5
unbalanced............................21
unbalanced, connecting ........28
traffic interfaces..........................20
traffic routing ..............................59
transients
preventing transmission of ....48
transmitter
frequency...............................62
muting....................................62
output power..........................62
transport safety panels...............26
TX/RX signal definition...............28
8
unbalanced interface............ 20–21
connector mounting...............28
username...................................60
UTP cable ..................................45
9
vertical polarization....................35
VLAN ................................... 65
, 67
voltage
hazards ...................................8
supply....................................11
voltmeter.............................. 80
–81
:
WARNING LED .........................47
web browser ..............................44
web pages
accessing ..............................60
backplane cross connect ......64
choosing................................60
Ethernet TIU configuration....65
RF channel configuration......62
RF path status.......................83
RF subchannel cross con. ....64
system information conf........61
traffic channel configuration ..63