User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGH[
WLDM001B
local management......................49
equipment..............................44
locking screw .............................37
login ...........................................60
0
M10 grounding screw holes . 14, 40
M10 screws................................37
M6 grounding lug ............11
, 19, 27
magazine
2U..........................................18
2U Installation Kit ..................18
6U..........................................18
6U Installation Kit ..................18
mounting of............................26
Mounting Rail for ...................18
Mounting Rail Screw for ........18
mounting the Indoor Unit in ...26
numbering of Indoor Units.....26
space requirements...............10
transport safety panels..........26
main lobe ...................................81
management
backplane connection............75
daisy-chaining .......................76
direct connection, static.........55
ECC connection ....................73
Ethernet connection ..............68
local.......................................49
modem connection.....70
, 75–76
remote ...................................68
Mast Mounting Bracket ..............34
fastening to mast...................38
mast requirements .....................13
mast stability ..............................13
Metral connector ........................20
modem .......................................45
AT commands .......................71
authentication........................71
bit synchronization status......83
cable .....................................45
connection set-up..................70
dial sequence........................71
disconnect sequence ............71
driver for null modem ............50
idle timeout............................70
initialize sequence.................71
mode .....................................70
telephone number.................70
MODEM/NMS2 port...................19
modular connector.....................19
moisture protection....................36
mounting pole diameter.............13
Mounting Rail.............................18
Screw ....................................18
muting the TX ............................62
MUX
bit synchronization status......83
port........................................59
1
N connector ......................... 33, 40
null modem driver ......................50
2
OH channel connector
9 pin D-SUB for OH ..............31
OH channels, see traffic channels
operating system for PC ............44
Operation and Maintenance ........5
operational modes .....................47
operational states ......................47
outdoor
EMC ......................................14
equipment .............................34