User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGH[
WLDM001B
common backplane connection .75
configuration
local management .................49
radio terminal.........................58
remote management .............68
connecting the power cable .......48
connector
26 pin D-SUB for ext. I/O. 17
, 31
37 pin D-SUB for traffic .........29
9 pin D-SUB for traffic ...........30
DC power ........................ 17
, 32
mounting................................28
N type.............................. 33
, 40
TNC................................. 17
, 33
contact person ...........................61
control panel ..............................19
copper braid.............. 11
, 14, 27, 40
cross connect.............................59
RF subchannels ....................59
traffic channels ......................59
'
daisy-chaining
connection set-up..................76
equipment..............................46
DC connector.............................19
Dial Up Networking
software.................................44
Windows 95/98................ 53
, 57
Windows NT.................... 52
, 57
dialling up
configuration..........................52
serial port...............................57
documentation .............................5
domain name .............................61
D-SUB connector
26 pin for external I/O.17
, 19, 31
37 pin for traffic channel........29
9 pin for modem ....................19
9 pin for OH channel.............31
9 pin for PC...........................19
9 pin for traffic channel..........30
DC power..............................32
dynamic IP addresses ...............79
(
ECC connection set-up..............73
electrical safety............................9
electromagnetic interference
indoor ....................................11
outdoor..................................14
elevation
fine tuning .............................82
screw.....................................81
EMC
indoor ....................................11
outdoor..................................14
environment
indoor requirements ..............12
outdoor requirements............15
errored second ..........................83
errored second rate ...................84
Ethernet
DTE.......................................19
Ethernet for management
cable .....................................45
connection set-up..................68
interfaces ..............................19
Ethernet TIU
buffers...................................65
configuration .........................65
connectors, mounting............30
duplex mode .........................66
enable ...................................66
flow control............................66
interfaces ........................ 20
, 23