User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QVWDOODWLRQ9HULILFDWLRQDQG7HVW
WLDM001B
6. Repeat step 3–5 above for the radio terminal at the far end of
the hop.
Background Block Error
during last second
1R
Errored Second Rate
Severely Errored
Second Rate
Background Block Error
Rate
RF Present Yes
RF Measured Power Compare this value with the
configured TX Output
Power.
3DUDPHWHU 6WDWXV