User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
$QWHQQD$OLJQPHQW
WLDM001B
$QWHQQD$OLJQPHQW
7RROV5HTXLUHGIRU$QWHQQD$OLJQPHQW
• 17 mm torque wrench
• Voltmeter (0–5V DC) with BNC adapter (the AGC contact on
the RFU is of BNC socket type).
3UHSDUDWLRQV
1. Check that all relevant instructions in the preceding sections
of this manual are completed for both installation sites before
you start aligning the antennas.
2. Arrange for speech communication between the installation
sites if possible. This will make it easier to align the antennas
correctly.