User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6LWH5HTXLUHPHQWV
WLDM001B
• Do not use any components (screws, nuts etc.) other than
those delivered together with the Allgon Microwave Radio
equipment or recommended by Allgon AB.
• Use the necessary safety devices (helmet, safety line etc.)
when working on, or around the mast. Be aware of the risk of
falling objects. Secure the integrated Antenna/Radio
Frequency Unit before lifting it up the mast.
%HU\OOLXP2[LGH
Some components in the Radio Frequency Unit contain beryllium
oxide (BeO) which is poisonous if inhaled as dust or smoke. This
can only happen if these components are damaged in some way.
The product is completely safe as long as the components are
not damaged.
Warning signs indicate parts containing beryllium oxide.
9ROWDJH+D ]DUGV
'$1*(5
'RQRWILOHJULQG PDFKLQH RUDSSO\DFLG WRSDUWVFRQWDLQLQJ
EHU\OOLXPR[LGH
'$1*(5
$OOVDIHW\SUHFDXWLRQVPXVWEHFDUULHGRXW&RQWDFWZLWK
SRZHUOLQHVFDQEHOHWKDO (YHQYROWDJHVEHORZ9 FDQEH
GDQJHURXV
Beryllium
oxide
hazard