User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
4. Perform a soft restart of the radio terminal for the changes to
take effect:
– Select
7HUPLQDO
→
6WDWH&RQWURO
and select Restart type
=
6RIW
.
– Wait until the radio terminal is in STANDBY state.
5. Go to the web page "Address Configuration" (
1HWZRUN
→
,3
$GGUHVVHV
) to verify the changes above.
6. Go to the web page "Network Interface Configuration"
(
1HWZRUN
→
,QWHUIDFHV
) and make sure that the status of the
serial port (LM/NMS 1 or MODEM/NMS 2) is set to "Up".
7. Exit the web browser and disconnect the serial PC cable
between the local PC and the radio terminal.
8. Make sure the remote manager is connected to the
management network, and that it is set up to work properly in
its environment. For further information, refer to the Operation
and Maintenance Manual (WLDM002).
9. Connect the radio terminal to the other radio terminal by using
the serial port (LM/NMS 1 or MODEM/NMS 2) on the BBU.
– For an LM/NMS 1–MODEM/NMS 2 connection, use a
straight-through serial cable with one 9 pin D-SUB plug
and one 9 pin D-SUB jack.
– For an LM/NMS 1–LM/NMS 1 connection, use a null
modem cable with two 9 pin D-SUB plugs.
– For a MODEM/NMS 2–MODEM/NMS 2 connection, use a
null modem cable with two 9 pin D-SUB jacks.
10. Proceed to section
$QWHQQD$OLJQPHQW
on page 80.