User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
&RQQHFWLQJYLD(&&
1. Allocate an IP address to the ECC port of the radio terminal in
one of the following ways:
– For set-up of a TCP/IP network on a ECC connection
using static IP addresses, allocate a static IP address,
subnet mask and broadcast address to the ECC port.
Refer to section
$OORFDWLQJ6WDWLF,3$GGUHVV
on page 78.
– For set-up of a TCP/IP network on a ECC connection
using dynamic IP addresses, configure the ECC port to
use dynamic IP addresses. Refer to section
$OORFDWLQJ
'\QDPLF,3$GGUHVV
on page 79.
2. Configure the ECC port by selecting
1HWZRUN
→
(&&
and
editing the following parameters:
3RUWQR 6ORWQR 8VHELWV
)RUFH
FRQQHFWLRQ
6HOHFWWKH
WUDIILFSRUWWR
XVHIRUWKH
(&&
Traffic ports
available for an
ECC are E1:1–
17, DS1:1–17,
and OH:1–2.
6HOHFWWKH
WLPHVORWWR
XVHIRUWKH
(&&
0–31 (E1)
0–23 (DS1)
&KRRVH LI E LW
VLJQDOO LQJ
VKRXOG E H
XVHG
Yes: The 7 most
significant bits
will be used.
No: All 8 bits will
be used.
&KRRVH
ZKHWKHUWKH
(&&VKRXOG
RYHUULGHDQ$,6
RUQRW