User's Manual

Table Of Contents
6WDUWXSDQG&RQILJXUDWLRQ

WLDM001B
CHAP secret (if CHAP is used); and
CHAP secret confirmation (if CHAP is used).
6. Perform a soft restart of the radio terminal for the changes to
take effect:
Select
7HUPLQDO
6WDWH&RQWURO
and select Restart type
=
6RIW
.
Wait until the radio terminal is in STANDBY state.
7. Go to the web page "Address Configuration" (
1HWZRUN
,3
$GGUHVVHV
) to verify the changes above.
8. Go to the web page "Network Interface Configuration"
(
1HWZRUN
,QWHUIDFHV
) and make sure that the status of the
serial port (MODEM/NMS 2) is set to "Up".
9. Exit the web browser and disconnect the serial PC cable
between the local PC and the radio terminal.
10. Make sure the remote management equipment is connected
to a remote modem, and that it is set up to work properly in its
environment. For further information, refer to the Operation
and Maintenance Manual (WLDM002).
11. Connect the radio terminal to a modem by using the serial
port (MODEM/NMS 2) on the BBU.
12. Proceed to section
$QWHQQD$OLJQPHQW
on page 80.