User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
4. Configure the modem AT commands for the serial port
(MODEM/NMS 2) by selecting
1HWZRUN
→
6HULDO,QWHUIDFHV
and clicking
&RQILJXUH
for the "Initialize sequence", "Dial
sequence" or "Disconnect sequence". Edit the following
parameters:
5. Configure the modem security by selecting
1HWZRUN
→
6HULDO
,QWHUIDFHV
and editing the following parameters:
– Authentication protocol (
1RDXWKHQWLFDWLRQ
,
3$3
or
&+$3
);
– PAP user (if PAP is used);
– PAP password (if PAP is used);
– PAP password confirmation (if PAP is used);
&RPPDQG 5HVSRQVH
(GLW$7FRPPDQGVIRU
LQLWLDOL]LQJGLDOOLQJRU
GLVFRQQHFWLQJWKHPRGHP
For the dial sequence, the
telephone number will be
automatically added after the
last command provided that
you have entered a value for
"Telephone number" above.
(QWHUWKH H[ SH FWH G
UHVSRQV HW RH DF K $7
FRPPDQG
Leave empty if no response is
expected.
Update the database with the new
settings for the AT command.
Delete the AT command in the
database.
Add a new AT command, entered on the
row "Add command", to the database.