User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
6WDUWXSDQG&RQILJXUDWLRQ
WLDM001B
4. Go to the web page "Network Interface Configuration"
(
1HWZRUN
→
,QWHUIDFHV
) and make sure that the status of the
Ethernet port (10baseT) is set to "Up".
5. Exit the web browser and disconnect the serial PC cable
between the local PC and the radio terminal.
6. Make sure the remote management equipment is connected
to the Ethernet LAN network, or to another radio terminal
connected to the Ethernet LAN network, and that it is set up
to work properly in this environment. For further information,
refer to the Operation and Maintenance Manual (WLDM002).
7. Connect the radio terminal to the network by connecting an
UTP cable to the 10baseT port on the BBU.
8. Proceed to section
$QWHQQD$OLJQPHQW
on page 80.